Siemens SCALANCE XR-500

Layer 2 management protocols
8.7 MLD Snooping (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
429
Result
The multicast forwarding entries are displayed.
Further notes
You enable MLD snooping with the ipv6 mld snooping command.
8.7.1.3
show ipv6 mld snooping groups
Description
This command shows the information about the MLD snooping groups for all or a selected
VLAN.
Requirement
● MLD snooping is enabled.
● You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show ipv6 mld snooping groups [Vlan <vlan id> [Group <Address>]]
The parameters have the following meaning:
Parameter
Description
Range of values / note
vlan
Keyword for a VLAN connection
-
vlan id
Number of the addressed VLAN
1 ... 4094
Group
Keyword for an MLD snooping group
-
Address
Address of the MLD snooping group Enter a valid address.
If you do not select any parameter from the parameter list, the configuration is displayed for
all interfaces.
Result
The information on the MLD snooping group is displayed.
Further notes
You enable MLD snooping with the ipv6 mld snooping command.