Siemens SCALANCE XR-500

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
539
9.3.4.8
no ipv6 ospf linkLSASuppres
Description
With this command, you enable the distribution of the LSA type "Link" on the link.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ipv6 ospf linkLSASuppres
Result
The LAS type "Link" is not distributed.
Further notes
You enable the setting with the ipv6 ospf linkLSASuppres command.
You configure the OSPF network with the
ipv6 ospf network command.
You enable OSPFv3 routing with the
ipv6 router ospf command.
You display information about the configuration with the
show ipv6 ospf interface
command.
9.3.4.9
ipv6 ospf metric
Description
With this command, you specify the metric for OSPF.
Note
This command is available only with layer 3.