Layer 3 functions
9.7 RIPng (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
611
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
ipv6 router rip
Description
With this command, you enable RIPng routing on the device change to the Router
configuration mode.
Note
This command is available only with layer 3 (IPv6).
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameter assignment:
ipv6 router rip
Routing with RIPng is enabled.
You are now in the RIPng router configuration mode.
The command prompt is as follows:
cli (config-ripng)#
You disable routing with RIPng with the no ipv6 router rip command.
You display the setting and other information with the
show ipv6 rip command.
To Next Page
Loading...
Need help?
General