Network protocols
7.1 IPv4 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
272 Configuration Manual, 11/2015, C79000-G8976-C252-10
The read and write permissions for the DPC server are configured.
The DCP server is enabled.
You disable the DCP server with the no dcp server command.
no dcp server
Description
With this command, you disable the DCP server.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
no dcp server
The DCP server is disabled.
You enable and configure the DCP server with the dcp server command.
ip domain lookup
Description
This command enables the DNS client of the device. To be able to use the function, a DNS
server must be reachable.
To Next Page
Loading...
Need help?
General