Siemens SCALANCE XR-500 - Ipv6 Mld Snooping Port-Purge-Interval

Layer 2 management protocols
8.7 MLD Snooping (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
433
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ipv6 mld snooping clear counters [Vlan <vlanid (1-4094)>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
vlan
Keyword for a VLAN
-
vlan id
Number of the addressed VLAN 1 ... 4094
Result
The counters are reset.
8.7.2.4
ipv6 mld snooping port-purge-interval
Description
The time after which a port is deleted from the list if no MLD packets are received is known
as the purge time.
With this command, you configure this purge time for a port or for a VLAN in seconds.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ipv6 mld snooping port-purge-interval <(130 - 1225) seconds>
The parameters have the following meaning:
Parameter
Description
Range of values / note
- Value for the purge time in seconds 130 ... 1225
Default: 260