Siemens SCALANCE XR-500

Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
648 Configuration Manual, 11/2015, C79000-G8976-C252-10
Result
The routing information is forwarded with a changed tag.
Further notes
You delete the setting that the tag of the routing information is changed with the no set tag
command.
You change to the Route maps configuration mode with the command
route-map.
You display the setting and other information with the
show route-map command.
9.8.3.22
no set tag
Description
With this command, you delete the setting that the tag of the routing information is changed.
Note
This command is available only with layer 3.
Requirement
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#
Syntax
Call up the command with the following parameters:
no set tag
Result
The tag of the routing information is not changed.
Further notes
You define the setting that the tag of the routing information is changed with the set tag
command.
You change to the Route maps configuration mode with the command
route-map.
You display the setting and other information with the
show route-map command.