Siemens SCALANCE XR-500 Configuration Manual

Network protocols
7.10 HTTPS server
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
376 Configuration Manual, 11/2015, C79000-G8976-C252-10
Result
HTTP is enabled on the device.
Further notes
You can display the setting of this function and other information with the show ip http
server status
command.
You deactivate HTTP on the device with the
no ip http command.
7.9.2.2
no ip http
Description
With this command, you disable HTTP on the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip http
Result
HTTP is disabled on the device.
Further notes
You can display the setting of this function and other information with the show ip http
server status
command.
You enable HTTP with the
ip http command.
7.10
HTTPS server
This section describes commands of the Hypertext Transfer Protocol Secure (HTTPS).

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English