Siemens SCALANCE XR-500 Configuration Manual

Layer 3 functions
9.6 RIPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
602 Configuration Manual, 11/2015, C79000-G8976-C252-10
The parameters have the following meaning:
Parameter
Description
Range of values / note
1
Only routing information corresponding
to RIPv1 (RFC 1058) is evaluated and
sent.
Routing information is only dis-
tributed and received using
broadcasts.
2
Only routing information corresponding
to RIPv2 (RFC 2453) is evaluated and
sent.
Routing information is only dis-
tributed and received using mul-
ticasts (224.0.0.9).
12
Only routing information corresponding
to RIPv1 and RIPv2 is evaluated and
sent.
Routing information is distributed
and received using broadcasts
and multicasts (224.0.0.9).
Default setting
none
There is no processing of routing in-
formation using RIP.
-
Result
It has been specified which RIP packets will be processed.
9.6.3.13
no version
Description
The updating of route information is according to RIPv1 or RIPv2 (default for this parameter)
Requirement
You are in the RIPv2 Router configuration mode.
The command prompt is as follows:
cli(config-rip)#
Syntax
Call the command without parameter assignment:
no version
Result
Both RIPv1 and RIPv2 packets are processed.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English