Siemens SCALANCE XR-500

Functions specific to SCALANCE
4.2 WBM
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
136 Configuration Manual, 11/2015, C79000-G8976-C252-10
Requirement
● The C-PLUG or KEY-PLUG is formatted.
● You are in the Plug Configuration mode.
The command prompt is:
cli(config-plug)#
Syntax
Call the command without parameter assignment:
write
Result
The current device configuration has been copied to the formatted C-PLUG or KEY-PLUG.
4.2
WBM
On the device, you can limit the time available for access with Web Based Management. If
no entry is made for a specific time, the WBM session is closed.
This section describes commands relevant for the configuration of this feature.
4.2.1
The "show" commands
This section describes commands with which you display various settings.
4.2.1.1
show web-session-timeout
Description
This command shows the timeout setting for the WBM.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show web-session-timeout