Siemens SCALANCE XR-500 Configuration Manual

Security and authentication
11.4 IP access control list
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
714 Configuration Manual, 11/2015, C79000-G8976-C252-10
11.4.5
Commands in the ACL standard configuration mode
This section describes commands that you can call up in the ACL standard configuration
mode.
In the Global configuration mode, enter the
ip access-list standard <acl-num> command,
to change to the configuration mode for this ACL. If an ACL with the specified number does
not exist, an ACL with the corresponding number is created.
Note
You can displ
ay existing access control lists with the
show access-lists
command.
● If you exit the ACL standard configuration mode with the exit command, you return to the
Global configuration mode.
● If you exit the ACL standard configuration mode with the
end command, you return to the
Privileged EXEC mode.
11.4.5.1
permit
Description
With this command, you configure an IP access control list. The IP ACL contains a
description of the IP addresses for which the incoming and outgoing frames will be
forwarded.
You have the following options:
● All incoming and/or outgoing frames are forwarded.
● Incoming and/or outgoing frames of a specific host are forwarded.
● Incoming and/or outgoing frames of hosts of a specific subnet are forwarded.
● Incoming and/or outgoing frames of a specific protocol are forwarded.
Note
Processing order of the lists
The access control lists are processed on the interface in the order in which they were
created.
The index number of the access control list is not used for this.
Requirement
You are in the ACL standard configuration mode.
The command prompt is as follows:
cli(config-std-nacl)#

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English