Siemens SCALANCE XR-500

Network protocols
7.6 DHCPv6 Relay Agent (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
339
7.6.4.4
ipv6 dhcp relay remote-id duid
Description
With this command, you specify the DUID (DHCP Unique Identifier).
Requirement
● The interface is an IPv6 interface.
● The DHCPv6 relay agent is enabled.
● In "
remote-id type", duid is set.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 dhcp relay remote-id duid <duid-id string(299)>
The parameter has the following meaning:
Parameters
Description
Range of values / note
duid-id
DHCP unique identifier Enter the DUID.
max. 299 characters
Result
The DUID is specified.
Further notes
You enable the remote ID with the ipv6 dhcp relay remote-id. command.
You enable the DHCPv6 relay agent with the
ipv6 address dhcp relay command.
You configure the interface as a router port with the
no switchport command.
You configure the remote ID type with the
ipv6 dhcp relay remote-id type command.
7.6.4.5
ipv6 dhcp relay remote-id userDefined
Description
With this command, you configure a designation for the remote ID.