Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
64 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
show ipv6 interface [{vlan <id> | <interface-type> <interface-id>} [prefix]]
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN 1 ... 4094
Type or speed of the interface Enter a valid interface
Module no. and port no. of the interface
shows the prefix information of the IPv6 interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameter from the parameter list, the configuration is displayed for
all available IPv6 interfaces.
The configuration is displayed.
You enable IPv6 on the VLAN interface or on the router port with the ipv6 enable command.
You configure an IPv6 address with the
ipv6 address command.
This command shows the current PROFINET IO configuration.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
To Next Page
Loading...
Need help?
General