Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
463
The virtual link is created.
You delete the virtual link with the no area virtual link command.
You display information about the virtual link with the
show ip ospf virtual command.
no area virtual-link
Description
With this command, you delete a virtual link.
Note
This command is available only with layer 3.
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
To Next Page
Loading...
