Siemens SCALANCE XR-500 - Page 464

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
464 Configuration Manual, 11/2015, C79000-G8976-C252-10
Syntax
Call up the command with the following parameters:
no area <area-id> virtual-link <router-id>
[authentication]
[hello-interval]
[retransmit-interval]
[transmit-delay]
[dead-interval
[{
authentication-key | message-digest-key <Key-id (0-255)>
}]
The parameters have the following meaning:
Parameter
Description
Range of values / note
area-id
Area-ID specify a valid ID.
x.x.x.x
x = 0 ... 255
0.0.0.0 = backbone area
router-id
ID of the router
-
authentication
Keyword for the authentication meth-
od of the virtual connection
•
simple
enables authentication using a
password
•
messagedigest
enables authentication using
MD5
•
none
no authentication
hello-interval
Keyword for the interval at which
Hello packets are sent over the virtual
link
-
retransmit-interval
Keyword for the interval after which
packets whose receipt was not con-
firmed are transferred again.
-
transmit-delay
Keyword for the time that a link state
update packet requires for transmis-
sion over the virtual link.
--
dead-interval
Keyword for the interval after which
the neighbor router is classified as
"failed" if Hello packets from it are not
received.
-
authentication-key
Keyword for the unencrypted pass-
word
-
message-digest-key
Keyword for the ID of the password -
key-id
ID of the password. specify the ID
0 ... 255