Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
455
area range summary
Description
With this command, you assign an area ID an address range. The address range is used to
group the routes within OSPF.
Note
This command is available only with layer 3.
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
To Next Page
Loading...
Need help?
General