Network protocols
7.4 DHCPv6 client (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
314 Configuration Manual, 11/2015, C79000-G8976-C252-10
You enable the function DHCPv6 client with the ipv6 address dhcp command.
You display the setting with the
show ipv6 dhcp command.
You configure the setting with the
ipv6 dhcp client information refresh minimum
command.
no ipv6 dhcp client information refresh minimum
Description
With this command, you reset the interval to the default value.
● DHCPv6 Is activated.
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Call the command without parameter assignment:
no ipv6 dhcp client information refresh minimum
The interval is reset.
You enable the function DHCPv6 client with the ipv6 address dhcp command.
You configure the interface as a router port with the
no switchport command.
You display the setting with the
show ipv6 dhcp command.
You configure the interval with the
ipv6 dhcp client information refresh minimu command.
To Next Page
Loading...
Need help?
General