Siemens SCALANCE XR-500

Network protocols
7.2 IPv6 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
281
Further notes
You configure a static entry with the ipv6 neighbor command.
7.2.2.2
show ipv6 pmtu
Description
This command shows the settings for Path MTU.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
show ipv6 pmtu
Result
The settings are displayed.
7.2.2.3
show ipv6 route
Description
This command shows the routes currently being used.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
show ipv6 route