Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
472 Configuration Manual, 11/2015, C79000-G8976-C252-10
no network area
Description
With this command, you remove the OSPF interface and the Area ID connected to the OSPF
interface.
Note
This command is available only with layer 3.
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Call up the command with the following parameters:
no network <network number> area <area-id>
The parameters have the following meaning:
Enter a valid network number
Area-ID enter an ID.
x.x.x.x
x = 0 ... 255
The OSPF interface is removed.
You create the OSPF interface and the area with the network area command.
You can display the status of this function and other information with the
show ip ospf
interface
command.
To Next Page
Loading...
Need help?
General