Siemens SCALANCE XR-500 - Show Vrrp Interface - Vrid

Layer 3 functions
9.4 VRRPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
550 Configuration Manual, 11/2015, C79000-G8976-C252-10
Result
The settings for the interface are displayed.
9.4.1.2
show vrrp interface - vrid
Description
This command shows the settings of a virtual router.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show vrrp
[
interface
{
vlan <VlanId(1-4094)>| <interface-type><interface-id>
}
<vrID(1-255)>
]
[{
brief|detail|statistics
}]
The parameters have the following meaning:
Parameter
Description
Range of values / note
vlan
Keyword for a VLAN connection
-
VlanId
Number of the addressed VLAN
1 ... 4094
interface-type
Type or speed of the interface
Enter a valid interface.
interface-id
Module no. and port no. of the inter-
face.
vrID
ID of the virtual router
1 ... 255
brief
shows brief information on VRRP
-
detail
shows detailed information on VRRP.
-
statistics
shows the statistics of the VRRP pro-
tocol
-
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".