Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
476 Configuration Manual, 11/2015, C79000-G8976-C252-10
no redistribute
Description
With this command, you disable distribution of routes with OSPF.
Note
This command is available only with layer 3.
● The router is an ASBR router.
You are in the OSPF Router configuration mode.
The command prompt is:
cli(config-ospf)#
Call up the command with the following parameters:
no redistribute {static | connected | rip | default | all}
The parameters have the following meaning:
Which routes are distributed via OSPF is disabled.
You enable the distribution of the routes with the redistribute command.
distribute-list route-map
Description
This command enables the filtering of the routing information according to a route map for
incoming routing information.
To Next Page
Loading...
Need help?
General