Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
524 Configuration Manual, 11/2015, C79000-G8976-C252-10
With this command, you remove an entry in the host table.
Note
This command is available only
with layer 3.
You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Call up the command with the following parameters:
no host <IPv6-Address>
The parameter has the following meaning:
IPv6 address of
Enter a valid IPv6 address
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The entry has been removed
You create an entry with the host command.
You display the host table with the
show ipv6 ospf host command.
To Next Page
Loading...
Need help?
General