Layer 2 management protocols
8.7 MLD Snooping (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
437
● The VLANs on the device are enabled.
● You are in the VLAN configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Call the command without parameters:
ipv6 mld snooping querier
MLD snooping is configured as querier.
You can display the status of this function and other information with the show ipv6 mld
snooping
command.
ipv6 mld snooping version
Description
This command specifies which version of MLD the device will use in this VLAN.
You are in the VLAN configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
To Next Page
Loading...
Need help?
General