Siemens SCALANCE XR-500

Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
583
Syntax
Call up the command with the following parameters:
no vrrp <vrid(1-255)> compatible-mode
The parameter has the following meaning:
Parameter
Description
Range of values / note
vrid
ID of the virtual router
1 ... 255
Result
The compatibility is disabled.
Further notes
You configure a VRRP3 interface with the interface command.
You assign IPv4/IPv6 addresses to a virtual router with the
vrrp associated -ip command.
You enable the compatibility with the
vrrp compatible-mode command.
You can display the status of the function with the
show vrrp3 interface - vrid or with the
show vrrp3 interface command.
9.5.5.7
vrrp preempt
Description
With this command, you specify that a router with higher priority can take over the master
role from a router with lower priority.
Note
This command is available only with layer 3.
Requirement
● An IP address is assigned to the virtual router.
● You are in the VRRP3 Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3-if-$$$)#