Siemens SCALANCE XR-500

Layer 3 functions
9.4 VRRPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
565
Syntax
Call up the command with the following parameters:
no vrrp <vrid(1-255)> priority
The parameters have the following meaning:
Parameter
Description
Range of values / note
vrid
ID of the virtual router
1 ... 255
Result
The priority is reset.
Further notes
You configure a VRRP interface with the interface command.
You create the priority with the
vrrp priority command.
You assign IPv4 addresses to a virtual router with the
vrrp associated-ip command.
You display the priority with the
show vrrp interface - vrid command.
9.4.4.10
vrrp text-authentication
Description
With this command, you specify that VRRP packets are authenticated using an unencrypted
password. If an incoming VRRP packet contains an invalid password, it is discarded.
Note
This command is available only with layer 3.
Requirement
● An IPv4 address is assigned to the virtual router.
● You are in the VRRP Interface configuration mode
.The command prompt is:
cli(config-vrrp-if)#
Syntax
Call up the command with the following parameters:
vrrp <vrid(1-255)> text-authentication <password>