Siemens SCALANCE XR-500 - 4 Functions Specific to SCALANCE; Plug; The Show Commands; Show Plug

SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
133
Functions specific to SCALANCE
4
This part contains the sections that describe functions specific to SCALANCE.
4.1
PLUG
The C-PLUG or KEY-PLUG stores the configuration of a device and can therefore transfer
the configuration of the old device to the new device when a device is replaced.
In addition to the configuration, the KEY-PLUG also contains a license that enables the use
of certain functions.
This section describes commands relevant for working with the C-PLUG or KEY-PLUG.
4.1.1
The "show" commands
This section describes commands with which you display various settings.
4.1.1.1
show plug
Description
This command shows the current C-PLUG or KEY-PLUG information.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show plug
Result
The current information of the C-PLUG or KEY-PLUG is displayed.