Siemens SCALANCE XR-500 - No Summary-Address

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
481
Result
The address range is created.
Further notes
You delete the address range with the no summary-address command.
You can display the status of this function and other information with the
show ip ospf -
area-range / summary-address
command
9.2.3.27
no summary-address
Description
With this command, you delete the address range.
Note
This command is a
vailable only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
no summary-address <Network> <Mask> <AreaId>
The parameters have the following meaning:
Parameter
Description
Range of values / note
Network
IP address of the address range
specify the IP address
Mask
Subnet mask of the address range
specify the subnet mask.
AreaId
Area-ID specify a valid ID.
x.x.x.x
x = 255
0.0.0.0 = backbone area
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".