Layer 2 management protocols
8.1 GARP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
389
Call the command without parameters:
gmrp
In the Global configuration mode: The GMRP function is enabled on the device.
In the Interface configuration mode: The GMRP function is enabled for this interface.
You need to enable GMRP globally for this device before you enable GMRP for individual
interfaces.
If you want to enable or disable the function for a specific interface on the device, use the
no
gmrp
command in the Interface configuration mode.
You can display the status of this function and other information with the
show vlan device
info
command.
With this command, you disable the GMRP function for all or individual interfaces on the
device.
You are in the Global configuration mode
or
You are in the Interface configuration mode
The command prompt is as follows:
cli(config)#
cli (config-if-$$$) #
Call the command without parameters:
no gmrp
In the Global configuration mode: The GMRP function is disabled on the device.
In the Interface configuration mode: The GMRP function is disabled for this interface.
To Next Page
Loading...
Need help?
General