Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
647
Call the command without parameter assignment:
no set metric
The metric of the routing information is not changed.
You define the setting that the metric of the routing information is changed with the set
metric
command.
You change to the Route maps configuration mode with the command
route-map.
You display the setting and other information with the
show route-map command.
With this command, you specify whether the routing information is forwarded with a changed
tag.
Note
This command is available only with layer 3.
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#
Call up the command with the following parameters:
set tag <value(1-0xffffff)>
The parameter has the following meaning:
Value of the tag 1 ... 0xffffff
Enter the new value for the tag with which the routing infor-
mation will be forwarded.
You can enter the value in decimal or hexadecimal.
To Next Page
Loading...
Need help?
General