Diagnostics
12.3 Loop detection
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
786 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call the command without parameters:
show loopd
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Information on loop detection is displayed.
show loopd interface
Description
Displays information on the loop interface.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command without parameters or with the following parameter assignment:
show loopd interface [{<interface
-type> <interface
-id> | port
-channel <port
-channel-id (1-8)>}]
The parameters have the following meaning:
Keyword for a an interface description
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
Keyword for a port channel connection -
Number of the addressed port channel
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameters from the parameter list, the default value is used.
The loop interface is displayed.
To Next Page
Loading...
Need help?
General