Security and authentication
11.4 IP access control list
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
720 Configuration Manual, 11/2015, C79000-G8976-C252-10
With this command, you configure an IP access control list for ICMP messages.
You have the following options:
● All incoming and/or outgoing ICMP messages are not forwarded.
● Incoming and/or outgoing ICMP messages of a specific host are not forwarded.
● Incoming and/or outgoing ICMP messages of hosts of a specific subnet are not
forwarded.
Note
Processing order of the lists
The access control lists are processed on the interface in the order in which they were
created.
The index number of the access control
list is not used for this.
You are in the ACL standard configuration mode.
The command prompt is as follows:
cli(config-std-nacl)#
To Next Page
Loading...
