Security and authentication
11.6 Management Access Control List
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
736 Configuration Manual, 11/2015, C79000-G8976-C252-10
Management Access Control List
This section describes the commands relevant for working with the management access
control list.
This section describes commands with which you display various settings.
show authorized-managers
Description
This command shows the information about the configuration of the authorized managers.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show authorized-managers[ip-source<ip-address>]
The parameters have the following meaning:
Keyword for the network or host ad-
-
Value for an IP address specify a valid IP address
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The information about the configuration of the authorized managers is displayed.
To Next Page
Loading...
Need help?
General