Siemens SCALANCE XR-500

Network protocols
7.2 IPv6 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
299
Requirement
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ipv6 address dhcp
Result
DHCPv6 is disabled.
Further notes
You enable DHCPv6 with the ipv6 address dhcp command.
You configure the interface as a router port with the
no switchport command.
You show the setting with the
show ipv6 dhcp interface command.
You can display the statistics of the DHCPv6 client with the
show ipv6 dhcp client
statistics
command.
7.2.4.6
ipv6 address link-local
Description
With this command, you assign a link local address to the interface.
Requirement
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#