Siemens SCALANCE XR-500 Configuration Manual

System time
5.1 System time setting
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
147
Syntax
Call up the command with the following parameters:
time{manual | ntp | sntp | SINEC | ptp_tc_client}
The parameters have the following meaning:
Parameter
Description
Range of values / note
manual
The system time is entered by the user.
-
ntp
The system time is obtained from an NTP server. -
sntp
The system time is obtained from an SNTP server.
-
SINEC
The system time is obtained using the SIMATIC time
protocol .
-
ptp_tc_client
The system time is obtained with the Precision Time
Protocol (PTP) from a grandmaster clock.
The following devices
support time-of-day
synchronization using
PTP:
• SCALANCE XR528-
6M
• SCALANCE XR552-
12M
Result
The method of obtaining the system time is configured.
Further notes
You display the settings for the system clock with the show time command.
5.1.2.2
time set
Description
With this command, you set the system clock.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English