Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
624 Configuration Manual, 11/2015, C79000-G8976-C252-10
This section describes the commands relevant for working with route maps.
With route maps, you control how routing information is further processed. You can filter
routing information and specify whether the information is further processed, modified or
discarded.
Route maps operate according to the following principle:
● Routing information is compared with the filters of the route maps.
● The comparison is continued until the filters of a route map match the properties of an
item of information.
● The information is then processed according to the route map settings:
– The routing information is discarded.
– The properties of the routing information are changed.
show route-map
Description
This command shows the configured route maps.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show route-map [name (1-20)]
The parameter has the following meaning:
If no parameters are specified, all configured route maps are displayed.
The route maps are displayed.
To Next Page
Loading...
Need help?
General