Network protocols
7.2 IPv6 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
296 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
no ipv6 address <prefix> <prefix Len> [{unicast | anycast | eui64}]
The parameters have the following meaning:
Enter a valid IPv6 address.
Number of bits belonging to the prefix
(from left to right)
1 ... 128 bits
64: With EUI-64
128: The node (host) and with link-
Addressing mode anycast -
Interface ID according to the EUI-64
-
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The IPv6 address has been deleted.
You configure the IPv6 address with the ipv6 address command.
You display this setting and other information with the
show ipv6 interface command.
ipv6 address dhcp
Description
With this command, you specify whether the DHCPv6 client obtains the (stateful) from the
DHCPv6 server or supports the function "prefix delegation" (
pd). When this function is
enabled, the DHCPv6 client becomes the PD router.
You can also change the prefix name. The requirement is that the prefix is not used by a PD
sub-client interface.
To Next Page
Loading...
Need help?
General