Layer 3 functions
9.4 VRRPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
551
The settings of the virtual router are displayed.
Commands in the Global Configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
With this command, you enable routing with VRRP and change to the VRRP Router
Configuration mode.
Note
This command is available only with layer 3.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameter assignment:
router vrrp
Routing with VRRP is enabled.
You are now in the VRRP Router Configuration mode.
The command prompt is as follows:
cli (config-vrrp)#
To Next Page
Loading...
Need help?
General