Layer 2 management protocols
8.6 Multicast
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
421
no mac-address-table static unicast
Description
With this command, you disable the "static unicast" function.
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
no mac
-address-table static unicast <aa:aa:aa:aa:aa:aa> vlan <vlan
-id(1-4094)> The parameters have the following meaning:
Specify a valid MAC address.
Keyword for a VLAN connection
Range of values of the VLAN
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select any parameters from the parameter list, the default value is used.
The "static unicast" function is disabled.
You activate the setting with the no mac-address-table static unicast command.
The commands in this section configure the procedures for handling Multicast frames.
The commands allow the following:
● Configuration of groups
● IGMP/MLD
● GMRP
● Blocking unknown Multicast frames.
With the "show" commands, you can display the configuration data.
To Next Page
Loading...
Need help?
General