Siemens SCALANCE XR-500 - No Interface

Layer 3 functions
9.4 VRRPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
554 Configuration Manual, 11/2015, C79000-G8976-C252-10
9.4.3.2
no interface
Description
With this command, you delete a VRRP interface.
Note
This command is available only with layer 3
.
Requirement
You are in the VRRP Router configuration mode.
The command prompt is as follows:
cli(config-vrrp)#
Syntax
Call up the command with the following parameters:
no interface vlan <vlan-id(1-4094)>
The parameters have the following meaning:
Parameter
Description
Range of values / note
vlan
Keyword for a VLAN connection
-
vlan-id
Number of the addressed VLAN
1 … 4094
interface-id
Module no. and port no. of the interface
Enter a valid interface.
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The VRRP interface is deleted.
Further notes
You configure a VRRP interface with the interface command.
You display the status and the configuration of the VRRP interface with the
show vrrp
interface
show vrrp interface - vridcommand.