Network structures
6.2 Link aggregation
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
206 Configuration Manual, 11/2015, C79000-G8976-C252-10
The Etherchannel settings are displayed.
show interfaces etherchannel
Description
This command shows the interface-specific information for a port channel.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show interfaces[<interface-type><interface-id>]etherchannel
The parameters have the following meaning:
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
If you do not select an interface, information for all interfaces is displayed.
The interface-specific information for a port channel is displayed.
Note
When a port is assigned to a link aggregati
on but is not active (e.g. link down), the values
displayed may differ from the values configured for the link aggregation.
If the port in the link aggregation becomes active, individual port configurations such as DCP
forwarding are overwritten with the c
onfigured values of the link aggregation.
To Next Page
Loading...
Need help?
General