Network structures
6.4 Passive Listening
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
255
With this command, you reset the revision number of the MST region to the default value.
The default value is 0.
You are in the MSTP Configuration mode.
The command prompt is as follows:
cli(config-mst)#
Call the command without parameters:
no revision
The revision number of the MST region is reset to the default value.
You assign a revision number to the MST region with the revision command.
You display this setting and other information with the
show spanning tree mst
configuration
command.
This section describes commands with which you display various settings.
show passive-listening
Description
This command shows whether or not "passive listening" is enabled.
To Next Page
Loading...
Need help?
General