Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
580 Configuration Manual, 11/2015, C79000-G8976-C252-10
Call up the command with the following parameters:
vrrp <vrid(1-255)> associated-ip [{ ipv4 <ip_addr> | ipv6 <ip6_addr> }]
The parameters have the following meaning:
Keyword for IPv4 address -
Enter a valid IPv4 address.
Enter a valid IPv6 address.
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
The IP addresses are specified.
You can create a maximum of 52 virtual IPv4/IPv6 addresses.
You configure a VRRP3 interface with the
interface command.
You remove an IP address with the
no vrrp associated-ip command.
You display the IP addresses with the
show vrrp3 interface - vrid command.
no vrrp associated-ip
Description
With this command, you remove an IP address from the virtual router.
Note
This command is available only with layer 3.
You are in the VRRP3 Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3-if-$$$)#
To Next Page
Loading...
Need help?
General