Siemens SCALANCE XR-500 Configuration Manual

Diagnostics
12.2 FMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
783
Result
Fiber monitoring is disabled.
Further notes
You enable this function with the fmp command.
You display the status of this function and other information with the
show fmp stauts and
show fmp limit commands.
You define the limit values with the
fmp power-loss and fmp rx-power commands.
12.2.2.3
fmp power-loss
Description
With this command, you specify the limit values for monitoring the power loss per port.
Requirement
You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
rmon power-loss [req]<1/10 dBm> [dem]<1/10 dBm>
The parameters have the following meaning:
Parameter
Description
Range of values / note
req
Specify the value at which you are informed of
the power loss of the connection by a message
of the severity level "Warning"
0 ... -55 dB
Default: -50 dB
dem
Specify the value at which you are informed of
the power loss of the connection by a message
of the severity level "Critical"
0 ... -55 dB
Default: -55 dB
Result
The limits for monitoring the power loss are defined.
Further notes
You enable this function with the fmp command.
You disable this function with the
no fmp command.
You display the status of this function and other information with the
show fmp stauts and
show fmp limit commands.
You define the limit values for the received power with the command
fmp rx-power.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English