Siemens SCALANCE XR-500 Configuration Manual

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
473
9.2.3.19
redist-config
Description
With this command, you configure the information for the route. The routes are further
distributed with this information.
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
redist-config <Network> <Mask>
[metric-value <metric (1 - 16777215)>]
[metrictype {
asExttype1 | asExttype2
}]
The parameters have the following meaning:
Parameter
Description
Range of values / note
Network
Target address of the route.
enter the IPv4 address.
Mask
Subnet mask of this route
specify the subnet mask.
metric-value
Keyword for the metric of the route
-
metric
Metric
1 - 16777215
metrictype
Keyword for the connection costs
•
asExttype1
External and internal costs
•
asExttype2
External costs
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 39)".
Result
The information for the route is specified.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English