Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
521
You delete the virtual link with the no area command.
You display information about the virtual links with the
show ipv6 ospf virtual link
command.
With his command, you specify that the router is an Autonomous System Boundary Router
(ASBR).
Note
This command is available only with layer 3.
You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Call the command without parameters:
ASBR Router
The autonomous system boundary router is enabled.
You disable the autonomous system boundary router with the no ASBR Router command.
You enable the distribution of the routes with the
redistribute command.
You create the information for the routes with the
redist-config command.
You can display the status of this function and other information with the
show ipv6 ospf
command.
To Next Page
Loading...
Need help?
General