Layer 3 functions
9.6 RIPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
595
Subnets are entered in the routing table summarized as class A, B or C networks.
no auto-summary
Description
This command disables the automatic summarizing of routing information.
You are in the RIPv2 Router configuration mode.
The command prompt is as follows:
cli(config-rip)#
Call the command without parameter assignment:
no auto-summary
Subnets are not summarized according to classes.
With this command, you specify the administrative distance for the RIP protocol. This value
is taken into account if routing information is learned from different routing protocols.
The lowest value for the administrative distance "1" means the highest reliability of the
routing information. Routing information from a system with the value "255" is so unreliable
that it is not learnt by the neighbor routers.
You are in the RIPv2 Router configuration mode.
The command prompt is as follows:
cli(config-rip)#
To Next Page
Loading...
