Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
544 Configuration Manual, 11/2015, C79000-G8976-C252-10
no ipv6 ospf priority
Description
With this command, you reset the router priority back to the default value.
Note
This command is available only with layer 3.
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Call the command without parameter assignment:
no ipv6 ospf priority
The priority is reset.
You enable OSPFv3 routing with the ipv6 router ospf command.
You configure the priority with the
ipv6 ospf priority command.
You display the configuration with the
show ipv6 ospf interface command.
ipv6 ospf retransmit-interval
Description
With this command you specify the time after which packets whose receipt was not
confirmed are transferred again.
Note
This command is available only with layer 3.
To Next Page
Loading...
Need help?
General