Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
579
Call up the command with the following parameters:
no vrrp <vrid(1-255)> accept-mode
The parameter has the following meaning:
The ping function to virtual IPv6 addresses is disabled.
You configure a VRRP3 interface with the interface command.
You assign IP addresses to a virtual router with the
vrrp associated -ip command.
You enable the ping function for virtual IPv6 addresses with the
vrrp accept-mode command.
You can display the status of the function with the
show vrrp3 interface - vrid or with the
show vrrp3 interface command.
vrrp associated-ip
Description
With this command, you specify which IP addresses the virtual router monitors.
Note
This command is available only with layer 3.
You are in the VRRP3 Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3-if-$$$)#
To Next Page
Loading...
Need help?
General