Network protocols
7.1 IPv4 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
271
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Call the command without parameters:
no telnet-server
The Telnet server is disabled.
You enable the Telnet server with the telnet-server command.
With this command, you configure the read and write permissions for the DCP server and
enable it.
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Call up the command with the following parameters:
dcp server {read-only|read-write}
The parameters have the following meaning:
only reading is permitted on the DCP
-
reading and writing is permitted on the
Default: read-write
To Next Page
Loading...
Need help?
General