Siemens SCALANCE XR-500 Configuration Manual

Diagnostics
12.1 Event and fault handling
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 11/2015, C79000-G8976-C252-10
773
Syntax
Call up the command with the following parameters:
no event config
{cold-warmstart|linkchange|authentication-failure|
rmon-alarm|power-change|rm-state-change|standby-state-change|
faultstate-change|stp-change|vrrp-state-change|loopd-state-change|ospf-state-
change|pnac-port-auth-state-change|poe-state-change|fmp-state-change|all}
{logtable|syslog|email|trap|faults
|all}
The parameters have the following meaning:
Parameter
Description
cold-warmstart
Message if there is cold or warm restart
linkchange
Message when there is a status change on a physical interface
authentication-
failure
Message if there is an incorrect login
rmon-alarm
Message when there is a RMON alarm
power-change
Message when there is a status change in the power supply
rm-state-change
Message when there is a status change in the redundancy manager
standby-state-
change
Message when there is a status change on a standby connection
faultstate-change
Message when there is a status change in the error monitoring
stp-change
Message when there is a change in the spanning tree
vrrp-state-change
Message on status change of VRRP routers
loopd-state-change
Message if there is a status change in the detection of network loops
ospf-state-change
Message on status change of OSPF
pnac-port-auth-
state-change
poe-state-change
Message on status change of PoE
fmp-state-change
Message on status change of FMP
all
All messages
logtable
Client that processes the logbook entries
syslog
Client that sends the messages to the Syslog server
email
Client that sends the e-mails
trap
Client that sends the SNMP traps
faults
Error LED lights up. The setting is possible only for a cold or warm restart.
all
All clients at once
Result
The setting deciding which messages of the device are not stored or forwarded is
configured.
Further notes
You display the status of the events and the clients with the show events config command.
You configure which of the various message types of the device will be stored or forwarded
with the
event config command.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English