Siemens SCALANCE XR-500 Configuration Manual

Network structures
6.3 Spanning Tree
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
232 Configuration Manual, 11/2015, C79000-G8976-C252-10
no spanning-tree (time settings)
Description
With this command in conjunction with the relevant parameter you reset the time settings of
the spanning tree function to the default values.
If you call the command without parameters, you disable the spanning tree function. The
configured time settings are retained.
If you call the
restart factory command, the system restarts with the factory configuration
settings All rime settings are reset.
The default values are as follows:
Parameter
Default value
forward-time
15 seconds
hello-time
2 seconds
max-age
20 seconds
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no spanning-tree{forward-time|hello-time|max-age}
The parameters have the following meaning:
Parameter
Description
forward-time
Time after which a port changes its spanning tree status from "Blocking" to
"Forwarding"
hello-time
Time after which the bridge sends its configuration frames (BPDUs)
max-age
Time after which the information of the BPDUs becomes invalid
Result
The selected setting for the time is reset to the default value.
Further notes
You configure the time with the spanning-tree command (time settings).
You display these settings and other information with the commands that start with
show
spanning-tree ...
.

Siemens SCALANCE XR-500 Specifications

General

Brand	Siemens
Model	SCALANCE XR-500
Category	Switch
Language	English